Made them up in one piece for my van. 1.6mm 18 gauge but no dimple pressings like you can get now. No crush tubes as I will use the factory style bolts with the step shoulder. I overlapped the front of the number one body member for a bit of extra bracing.


Sent from my iPhone using Tapatalk

Made them up in one piece for my van. 1.6mm 18 gauge but no dimple pressings like you can get now. No crush tubes as I will use the factory style bolts with the step shoulder. I overlapped the front of the number one body member for a bit of extra bracing.


Sent from my iPhone using Tapatalk

all you needfor the dimples is some round bar and a bit of pipe.smash the round bar into the pipe .it will give a similar look .....or press it if ya got one.

the stark ones are 180 bucks.they look good though

Nothing special. But easy to make. I made it out of 2mm for extra strength. Welded rhs on other side and will use pipe for crush tube. Sorry no pics of that yet

Sent from my CPH1725 using Tapatalk

sorry .dont know why no pic is there
i will try again

as that so you can look up the girls dresses?

This what I did for the front of mine

Sent from my CPH1725 using Tapatalk

i reckon retro spares is getting them from the same guy in queensland,i bought it from victoria but it came from queensland looking at the postage
anyways its a decent bit of stuff.im about to buy an english wheel .i was going to make one and was thinking i would just buy one to see how good it was.if it was crap id just sell it on.its so good im using it,sav ing me 1000 dollars right now for the wheel and shrinker stretcher i would have needed to make it

i think thats a great price...good on ya

Sorry Wayno for slower response...   I'm guessing your talking about the lower lower rear quart panel,  my answer is just buy one and welder it in. 

ok got ya.where you getting panels from?i just bought a tailgate skin off retro spares..its really good.i was pleasantly surprised

good price

pm me

i
have one
.im in reservoir vic
free to good home

how are you gonna put in the compound curve?

do you have english wheel?

just ask on here as you get to each problem.
usually someone will post inf for you quicker than you may think
good luck with the build!!!

I'm happy I can move forward  knowing there's no rust anywhere in the firewall now.

Sent from my CPH1725 using Tapatalk

Got some rust done where subframe bolts on, and decided to delete wiper motor and wiring loom holes. Seems like I've done so much but hardly anything to show for it in the last week. All those little details take time that no-one sees. I'm happy though.

Sent from my CPH1725 using Tapatalk

Glad I took the subframe off....found all this nasty stuff. How's that rusty subframe bolt???

Sent from my CPH1725 using Tapatalk

Walk the front clip off?


Sent from my iPad using Tapatalk

yep!
i didnt need to wait till monday  to borrow my mates engine crane...
got it done!

So the booster was out..... Well I need to prep the area...... Oh well better get the engine out and do it properly.
But I don't have an engine crane. Hmm I know to get it out!

Sent from my CPH1725 using Tapatalk