Hi all.Thanks stinky.I thought it was in the wright place for the ad.Thanks gary.

Hi to all why has my post in wanted been locked.i cannot access it.cheers gazza.

Hi all I am looking for a pair of wiper arms for a fc holden.I need them for my project.Not the arms that are under the dash. the ones that sit on the out side of the windscreen.Thanks Gazza.

Hi brett.very nice car.What car are those wheels of and are they the same size as the other wheels you had on the car.thanks Gazza.

morning all.this set up works for a one piece tail shaft how do you set up for the two piece shaft like commodore.cheers gazza.

hi all i have ran at 4 degrees to the up.cheers gazza.

  thanks fe4me.downloaded the file yesterday all is good had a read of it and there is lots of good info. cheers gazza.

i fe 4 me .i resent the funds.the bank would not let me send the funds unless i left out the word management and the dash in account details so all is good. cheers gazza. 

hi fe 4 me. the bank says your account number and name is wrong. i tried to do a bank transfer and it would not send funds.cheers gazza. 

i would like a copy .how do i get one.cheers gazza.

hi all. can i use hk stub  axles and steering arms on a uc torana front end.if not what are the problems.cheers gazza.

hi all if anybody has a pbr parts book can they tell me what these are of master cylinder has two numbers c450 and 4m6.and what size is the cylinder bore.booster is vh12516L6d.cheers gazza.

hi brett pm sent.cheers gazza.

hi bret which engineer are you using.cheers gazza.

hi all. just found out from the commodore site that the ve commodore twin piston calipers have a smaller piston than  the vt commodore. i can use the 15/16 master i do not have to up grade to a 1 inch master.i need to know if the vl master is okay to use as it was a drum brake set up on the rear now it is disc .cheers gazza.

hi all.would a vl brake booster and master cylinder be okay to use on a fc with disc front and rear front has twin piston calipers rear end is vl commodore did have drum brakes now has vn disc. front are ve commodore.cheersgazza.

hi brett.did you have any probs when you put the small center cap on the front wheels.did you leave the dust cover of the torana stub axle i have the same setup as you and the same wheels as you and i find that the dust cover goes on and the small center cap does not fit.  what did you do to fix the probs. cheers gazza.

hi pete can you make me a set of saddle plates 60mm from diff to spring. and bottom plate 57mm wide flat piece to sit on spring. set up is for a vl commo diff for my fj holden diff  does not  have to be shorten . i dont need  the ones that fit over the tube. i will be using the u bolts from the 2 inch lowering blocks. i was going to use  2 inch lowering blocks but your way is better. also can you please pm me with a price. or do you have a number i can ring.cheers gary.    

hi all in regards to what fchoon said about the signal unit for over drive or the power switch i rang castle auto elec if you have a auto gear box the wiring set up will cost around 850 dollars you need also a speed sensor which regulates the fuel or car will run rich which will cost 250 dollars. if you run a manual gear box the wiring loom will cost 550 dollars and you will need the speed sensor as well.cheers gary.

hi pedro no prob. im putting the same engine in my fj holden i am going to reverse the sump  patrol sump are very high priced.thanks gary.