carby linkages on red motors

[Phantom]

           G'day all, was wondering if any one can send me or post pics of their carby linkage set ups on red motors running twin carbs (my linkages are a bit of a mess and need tidying and tightening up)
                            Cheers Rusty
       rustyfc@gmail.com

[SRVLIVES]

hey Rusty, here's mine, 'scuse the pics, my shed is really dark and scary at night! :o

Hope they help some.

[TorqueFC]

The setup in Shane's post are pieces of rod and "W Clips". You can go to bursons/autobarn places like that and they can order W clips in for you, or you could just buy a brand new linkage kit to suit your application . ;) ;)

[Phantom]

Cool, thanks for the pics SRV,  but i didnt explain myself properly, i need pics from the accelerator bar? to the carby ? does that sound right?
                      Cheers Rusty

[SRVLIVES]

I thought as much... but as you can see, my car and my carbs are not yet as one!

[Glenn 'Stinky' Stankevicius]

Here's one from the Nats that I got, I have a few others but mainly greys. Probably the best shot is fehotrod's FE. I had to lighten the shot so some detail is lost.

[Phantom]

Thanks Stinky , but alas i have nearly exactly the same pics, but dont show enough detail of the side i want, cheers big fellah, Rusty

[TorqueFC]

there is a grey motor setup, but this is the messy way, and you wouldnt run a setup like this on an x2 manifold as you dont have a divorce setup...

[Jockster]

G'day Rusty
I went in and took a few pics of the X2 carb set up on my FC, they are a little dark but might show you what you want. The various holes in the throttle linkage allow you to usr different length rods to alter pedal travel and lightness
Cheers
Jockster

[Phantom]

Thanks heaps Jockster, just what i needed , cheers mate
                      Rusty