FE front blinker

[Not Happy Jan]

Afternoon,
I have an earthing problem with my front RHS blinker. I have power to the assembly, test it with a multimeter and it shows power. Put in the bulb and nothing. Surely it is earthed when it's screwed to the body??
Not a sparky's bootlace. Nick

[ardiesse]

Nick,

With the bulb in the socket, repeat the test with the multimeter, but with the positive lead on the indicator housing and the negative lead on a known good earth, for example the front bumper.  If the multimeter shows voltage when the indicators flash, you have a bad ground connection between the indicator housing and the car body.

Undo the mounting nuts and pull the indicator housing out.  Wire-brush the mounting studs clean.  Wire-brush or sand around the mounting holes on the inside of the fender.  Put external-tooth lockwashers between the nuts and the body.  Tighten down securely.

Rob

[Not Happy Jan]

Thanks Rob,
Ok this is wierd.
No current on the housing.
Check power on OK. Test with multimeter and light tester.
Connect up to blinker assembly and I don't get a reading when I'm testing at the connection site. I literally have the circuit tester on the end from the car and its testing ok. plug in the blinker assembly without touching the tester and no power???

[Not Happy Jan]

I cleaned everything up.

[Not Happy Jan]

Sorted
Flasher. :-[