Rear boot panel and boot extension panels wanted.

[Stash]

I am after these panels if possible:

1x Boot rear panel. The one that has a hole for the petrol filler
It has a 90 bend along the edge.



L & R Boot extension panel. as you can these are rusted out on mine. (and probably on most)



PM if you can help

Cheers

Stash

[fe350chev]

You can't buy these they gotta get cut from a good car or made. You might be best cutting the lip out at the corner and welding a new folded and shaped bit back in. I'm about to do a section of mine maybe late this month and I am borrowing a mates engineering joint which has all the gear. So I'll ask him about it for you. If he says it's easier to do a whole piece then I'll do you one if it's not too Labour intensive (I'm already doing 2 at once 😨 cos I'm stupid) but my son is pretty crook so I've dropped behind. I have a question. Has it been blasted yet? Can you pm me better pics say along 3 sections along boot lip and mark the rust holes on the panel part. With my custom fe, I was gunna cut the whole section out on one side to make a battery or other compartment for whatever, but my concern is if it's boxed up too much, it might look funny from the side. So can u also pm me better pics of both sides then I'll compare to mine and I could possibly make some more but I wasn't planning on spot welding but plug welding but we have the ability to spot but I don't see the point if you get me. I'll try help you but hesitant as I don't know you if u get me. It's a tricky section depending on where it's stuffed. If you have pin holes sporadic on the outer, just drill holes in them and weld them with mig. Then we could send you the inners. Send pics anyway and I'll show the guys and maybe come up with some sort of a quote but I'm not quite up to that yet so not sure of your timeframe.

[Stash]

Thanks for the comments fe350chev... albeit late.

Bump!!! Still looking for back panel with the petrol hole and left rear lower quarter.
Also if anyone has a tyre well, would be interested in that.

[Glenn 'Stinky' Stankevicius]

I might have a tyre well, I'll check and let you know.

[Glenn 'Stinky' Stankevicius]

You could try Shane's Metal Fabrication on Facebook for the other gear, Adelaide guy.

[collecta]

What happened to the spotless tyre well i gave you?

[Stash]

Thanks Stinky.

[Stash]

@Collecta I might have to check. I dont think i have a tyre well.

[collecta]

I definitely gave you one, still have the shell i took it out of.

[Stash]

if you saw so Scotty...
I will check. down in Adelaide next week.

John

[Stash]

say.. ???

[Stash]

@Collecta - Scotty - i stand corrected.
There is a beautiful new tyre well in the boot!!

thanks 1m x

[Stash]

Does anyone have a good boot rear panel?
or left rear quarter and inner?