News:

Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.

Main Menu

Fuel Pump Service Kit for 6 cyl red motor

Started by KFH, January 22, 2016, 02:25:11 PM

Previous topic - Next topic

KFH

Where is the best place to find a fuel pump service kit for 6 cyl red motor.  They seem to be getting scarce now.

Keith
I was born with nothing and still have most of it left

FCRB26

My local bloke had a few i cleaned him out as thats the pump we use on our old brobo saw..

I had to buy a new one recently 140 odd dollars could not find a kit.

ardiesse

There are a couple of sources.

One is classiccarbs.com.au (he's located in Queensland), and has a wide range of AC fuel and vacuum pump kits.

The other is chevsofthe40s.com.  From the looks of the seals in the picture and my memory of those in a red motor fuel pump kit, repair kit 5592988 ('52-'57) would be the go.

I think they both get their kits from the same supplier.

Rob
Remember: if your Holden's not leaking oil, it doesn't have any.

Trevor_B

Hi Keith,
Try this guy, his stuff is always good: [ebay]151794859038[/ebay] $129 + postage.

He knows his Holdens especially HK,T & G

Cheers,
Trevor_B
FC Sedan, Ute & Wagon .... only a Panel Van required to make the set

KFH

Thanks all for the leads.  I will investigate.

Keith
I was born with nothing and still have most of it left

FC Dave


KFH

I contacted Classic Carbs. They are currently waiting for one part and I should have one in a few days.  Thanks FC Dave for your information.

Keith
I was born with nothing and still have most of it left

KFH

I picked up the kit from Classic Carbs yesterday.  We were only a few k away from them.  Gavin, the owner, told me he has the rights to use the Gos dies to cut all types of gaskets. He also told me that he can do the full kits for the grey motors with the vacuum pumps.

Keith
I was born with nothing and still have most of it left

Sheriff

Keith, I bought one of his grey motor kits for my vacuum pump but the rubber seal that goes on the diaphragm shaft is the wrong size.   The local guy at Express Engineering in Toowoomba has some NOS Goss kits for grey motors.   Had to buy another full kit off him to get the right seal.  Mike