Inner sills

[FCRB26]

Just thought i would show pics of NOS inner sill might give a insight for people re building theres.

[FATBOY]

no excuses not to reproduce them now pete
regards fatboy

[FCRB26]

Ha ha is "I couldn't be stuffed good enough"

Big thanks to fatboy for the inners

[fe350chev]

Yeah. Even half cut fronts. That's what u need to make me 😉

[FCGos]

Pete

Thanks for the pics as I am close to having to refabricate these and the pics are a great help in determining profiles etc.

Cheers
Wayne

[JB]

Not that I need any anymore, but how hard is it to make the front part or stamp the front part where it rusts the most?

[weddo]

Great photos Pete,
Any chance of some dimensions from a fixed point for those that have to re fabricate (like me) some time, when you have time  :)

regards
Weddo

[FCRB26]

I shall get some measurements before they go in.
The stepped Bit should be easy

[Crumpsnr]

Pete, if you could be convinced to do a run you could put me down for a LHS from the last circle forward! Martyn

[FATBOY]

i made a template years ago to fabricate the front bit but is lost now upto u pete
regards fatboy

[fe350chev]

When I get home I'll see if my engineer mate has the template on paper/computer.

[FireKraka]

I'm going to throw my hat into the ring there as well Pete put me on the list if you are going to do a run mate.

regards
Neil H

[weddo]

I shall get some measurements before they go in.
The stepped Bit should be easy

That would be very much appreciated Pete

regards

Weddo

[Wasim]

I would put my hand up for both LHS and RHS sections

Regards, Wasim

[Not Happy Jan]

yes please Pete
L and R

[fe350chev]

Are you there Pete? I hope your not found rocking in the corner somewhere

[Gman]

What are the two approx 1/4 inch holes for in the rh inner sills?, a pair of crappy second hand ones i have, have the same holes...

[snuff69]

For the clips that hold the fuel and brake lines   Dave

[Gman]

I didn't even get to finish reading the reply before i had an 'oh, derr' moment ;D