Attention : Station Sedan owners

[Glenn 'Stinky' Stankevicius]

I would like to get a few measurements of the distance between the rear wheel tubs just behind the square plates that cover the top shock mounts.
I have 107cm and the cargo vinyl comes to 106cm.

Thanks in advance.

[hsv-001]

Mate ,my van measures 1074mm between tubs over shock centres . Got some advice to ask of you .I have never made a hood lining before but have made the top for my convertible Vauxhall [ have an old pre war Singer and a Pfaff ] is it just a matter of making the patterns for each section[between the bows] and sewing them together with a loop for the hood bows and enough excess to glue the edges .I would assume that there are a few tricks of the trade I would have to look out for . Any advice would be appreciated . Thanks Haydn

[GMHwagoon]

glenn     pm sent

[Glenn 'Stinky' Stankevicius]

Got some advice to ask of you .I have never made a hood lining before but have made the top for my convertible Vauxhall [ have an old pre war Singer and a Pfaff ] is it just a matter of making the patterns for each section[between the bows] and sewing them together with a loop for the hood bows and enough excess to glue the edges .I would assume that there are a few tricks of the trade I would have to look out for . Any advice would be appreciated . Thanks Haydn

1. If you are using a domestic sewing machine, don't, the stitch length will probably not be long enough meaning too many perforations and it will likely rip when fitting.
2. I have always used an old lining for a template, but you method sounds right.
3. Don't sweat the little creases when fitting, they'll come out with a heat gun or on a hot day.

[hsv-001]

I have an old industrial singer and a pfaff which I used to make the top for my Vauxhall so If I can get the pattern correct I think It will be OK . Thanks ,I think I just need the confidence to get started . Haydn

[fe350chev]

I'd like to have a go one day at some of this stuff too.