Benchseat Floorshift

[superfly]

Hey everyone,

I was just wondering whats the go with fitting a benchseat to an fc that has had a 4 speed manual slotted in?

And also how hard is it to fit an EK steering column to an FC?

cheers Matt

[FBvisitor]

G,day Matt,

Regarding the seat, I have seen a notch about six inches wide and a couple of inches deep made in the front which looks spot on. Perhaps a trip to the seat trimmers is in order?

Cheers, Jason.

[Digger]

G'Day Matt.

Check the tech info area out you might find it interesting
 Â   "AUSSIE 4 SPEED ADAPTER FOR A BENCH SEAT"

http://www.fefcholden.org.au/techinfo/tech004.html


Steve

[RET]

The EK column is a bolt in swap.  If you take the front seat out it can make your life much easier doing this, as it gives you a lot more room to maneuvre the column out from the firewall.

If you're planning on fitting the FC wheel to the EK column, it does shorten the column by about 3-4 inches (which I suspect is what you're after), but it means there is very little clearance between the seat and the bottom edge of the wheel for your legs!

cheers
RET

[Jonno]

Hi Matt,

If you want to go with Jason's suggestion above, this is what it will end up looking like (also note EK column which, ironically, I want to take back to FE)

Jon