News:

Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.

Main Menu

Deleting Heater Hoses

Started by Ol_Girl_58, April 11, 2009, 07:50:20 PM

Previous topic - Next topic

Ol_Girl_58


Hi all,

This is probably a very simple question, yet still one that I would like to know the answer to. I'm soon going to take charge of a new engine (or motor, whatever floats your boat), but I would like to delete the heater hoses. I have a big ugly heater in the car (out of a Nissan Skyline) that doesn't look great or even work, for that matter. So, I want to get rid of it. But what do I do with the heater inlet bit on the engine block?

Cheers,

Ol_Girl_58 

Glenn 'Stinky' Stankevicius

Got a picture of it? That would certainly help as it could be any number of heater setups.

EffCee

If you are fitting a red engine then there is a thread that screws into the head, simply remove the existing tap and screw a blank plug into the head. Where the heater comes off the water pump there used to be blanking caps from GMH to suit. Try your Holden dealer to see if these are still available. Alternatively a bolt into a piece of heater hose will do the trick. Another alternative is to replace the water pump and fit one that does not have the hole drilled for the heater hose.


HTH

Keith
Canberra, ACT

F4+ ;)

Ol_Girl_58


Thanks for the reply Keith.

Stinky, I don't have any great shots, and these probably won't help.





These are photos of the engine in its' previous home - an LJ GTR Torana - soon to be installed into the FC (Webers are coming too).

Cheers,

Ol_Girl_58

Paul In Ireland

Well, if you can't work it out, give that new motor (engine) to me and I'll fit it with the broken heater  ;D

You can have a decent grey in a fair swap!

The International FE FC Fleet of Ireland
Education is where you read the fine print. Experience is what you get when you don't.

Ol_Girl_58


Hi Paul,

I'm pretty sure the new engine (motor) isn't set up to run on leprechauns, Guinness or four-leaf clovers. I guess it'll just have to stay with me.  :-\ :-\  :-*

Cheers,

Ol_Girl_58

Spinner

Not quite related...

On a 253 in a HT, many years ago, i used a rubber blanking off cap that you could buy, with a five cent coin under it.  The coin is about teh same size as the OD of the outlet and helped prevent blowing the rubber cover apart.
(0414) 49-6706.  d5461 on Ebay.