News:

Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.

Main Menu

FITTING OF FUEL TANK

Started by FATBOY, August 17, 2008, 03:28:19 PM

Previous topic - Next topic

FATBOY

What type of caulking do you use between the tank and the floor
regards fatboy
fatboy
0414712441

JB

Hey Fatboy,

I used sikaflex... That sorted it. Until I put a hole in it. Real bitch to get out, but would use again.

Cheers
Jason.

Phone +64 223509263

FATBOY

Kool i use sikaflex all the time will go under the house and get some and put the tank in the ek ute now
regards fat
fatboy
0414712441

FC427

Fatboy Butyl Mastic ......FC427.........
As I lay rubber down the street I pray for traction I can keep, but if I spin and begin to slide please dear god protect my ride

FX1975

I also use a mastic type sealer as is agood seal and easier to remove tank if necessary than sikaflex
                                             cheers
                                               Frank

weddo

Definitely Butal Mastic(warm it up in a bucket of hot water before you use it) it will seal but not harden, where as Sikaflex will cure and become like an adhesive. 

regards
Weddo