V6 Conversoion

[hrpremier]

I was hoping someone out there who has already completed a V6 conversion into a FC could give me a list of primary parts useful to complete the project.  I have my complete donor car and have stripped the wiring loom, steering colum interior at this stage but not sure what exactly I need to make the conversion easier. I plan to use as much running gear from my vs donor car as possible ie brakes etc so with that in mind any help is greatly appreciated.  I know its a bit of an open ending question but not sure what I am getting myself into.  I have an engineer to do the conversion but he's out of the country on holidays at the moment so he's unatainable.

Thanks in advance

Jase
4869

[old-blu]

Hi Jase. Where abouts in Oz do you reside? I have completed a VS into a Ute using an Insurance wreck. I used an HR front end with with a rear mounted shortened Commodore rack. The sump modification is available, as is the wiring loom to the original dash units. Happy to help if I can. I used a VN oil filter & fitting to make room for an Idler pulley out front for A/Con. Most parts are available. I wanted to use Struts for the front suspension, however, even by cutting down the inner skirts , still ran out of room.  There are workshops now that do a " drive in / drive out " conversion. Cheers old-blu.

[hrpremier]

Old Blu.

I am located in Cairns FNQ so no doubt to far away from much assistance in person.  Not to many members on the forum this way I bet.  Any photos or pointers would be appreciated.

Kindest Regards


Jase

4869

[JB]

Mate, give me a call...

0414677688

I can show you the way.

Cheers
Jason.

Cairns... Gods country!!! Thats why I am here.